Studebaker 1963 – 1964 Avanti Aluminized Factory Exhaust Pipes
Studebaker 1963 – 1964 Avanti Aluminized Factory Exhaust Pipes
You get 8 aluminized pipes, 1963-1964 Studebaker Avanti R-1 or optional R-2 engine. If you need the R-3 or R-4 system, just email me.
The 8 aluminized pipes were all bent by Nostalgic Motor Cars
This is the only system available that was bent from the original Avanti Motors supplied blue prints, and all pipes were jig fit after the bending process was complete. This was an Avanti Motor Corporation requirement. The pipes are all 1/2 “- 1 “ longer than the blueprint requirements. As it is very easy to shorten, but difficult to adjust if the pipes are all too short.
This system will not fit 1965-1985 Avantis
The Avanti exhaust system is one of the most difficult systems you will ever install, if not bent according to blueprints. It has to clear the steering control valve and hoses, the oil filter, through the frame x-member, over the axle clearing the rear brake hose and finally, clearing the spare tire well.
Avanti Motors would have told you that you may have to install some flats as needed or slightly tweak the system for clearance.
This Kit contains:
1 – 1st Left Aluminized Exhaust Pipe
1 – 1st Right AluminizedExhaust Pipe
1 – 2nd Left AluminizedExhaust Pipe
1 – 2nd Right AluminizedExhaust Pipe
1 – Left Aluminized Resonator Eliminator Pipe
1 – Right Aluminized Resonator Eliminator Pipe
1 – Left Aluminized Tail Pipe
1 – Right Aluminized Tail Pipe
Nostalgic Motor Cars is the world’s oldest supplier, and manufacturer of Avanti Motors exhaust parts. We made service exhaust for Avanti Motors, since 1977.