- Exhaust -
- Exhaust Systems & Kits
- Avanti Factory Exhaust System 1966 – 1974 - Aluminized
Avanti Factory Exhaust System 1966 – 1974 - Aluminized
1966 – 1974 Avanti Factory Exhaust System
You get 8 aluminized) pipes, 2 aluminized steel mufflers (Glass Packs or Quiet Tone)
for the 1966 (must have 2” exhaust manifolds)-1974 Avanti.
The mufflers are the proper length and are round and seamless. Both the glass packs or the two chambered quiet tone mufflers look exactly the same on the outside. The 8 stainless (409) pipes were all bent by Nostalgic Motor Cars, we made Avanti Motors service exhaust parts for them, since 1977.
This is the only system available that was bent from the original Avanti Motors supplied blue prints, and all pipes were jig fit after the bending process was complete. This was an Avanti Motor Corporation requirement. The pipes are all 1/2 “- 1 “ longer than the blueprint requirements. As it is very easy to shorten, but difficult to adjust if the pipes are too short.
This system will not fit 1963-1964 Studebaker Avantis
The Avanti exhaust system is one of the most difficult systems you will ever install, if not bent according to blueprints. It has the clear the steering control valve and hoses, the oil filter, through the frame x-member, over the axle clearing the rear brake hose and finally, clearing the spare tire well.
The factory would have told you that you may have to install some flats, as needed or slight tweaking of the system, for clearance.
This Kit contains:
1 – 1st Left Aluminized Exhaust Pipe
1 – 1st Right Aluminized Exhaust Pipe
1 – 2nd Left Aluminized Exhaust Pipe
1 – 2nd Right Aluminized Exhaust Pipe
2 – Round aluminized Mufflers Seamless
1 – Left Aluminized Resonator Eliminator Pipe
1 – Right Aluminized Resonator Eliminator Pipe
1 – Left Aluminized Tail Pipe
1 – Right Aluminized Tail Pipe
Nostalgic Motor Cars is the world’s oldest supplier and manufacturer of Avanti Motors exhaust parts, we made service exhaust for Avanti Motors since 1977